KIA Sportage 2010 User Manual

Page 281

Advertising
background image

5 49

Driving tips

1

2

3

4

5

6

7

8

9

Reprogramming a single
HomeLink button

To program a device to HomeLink
using a HomeLink button previously
trained, follow these steps:
1. Press and hold the desired

HomeLink button. Do NOT release
until step 4 has been completed.

2. When the indicator light begins to

flash slowly (after 20 seconds),
position the hand-held transmitter
1 to 3 inches away from the
HomeLink surface.

3. Press and hold the hand-held

transmitter button (or press and
“cycle”

- as described in

“Canadian Programming” above).

4. The HomeLink indicator light will

flash, first slowly and then rapidly.
When the indicator light begins to
flash rapidly, release both buttons.

The previous device has now been
erased and the new device can be
activated by pushing the HomeLink
button that has just been pro-
grammed. This procedure will not
affect any other programmed
HomeLink buttons.

Gate operator programming &
canadian programming

During programming, your hand-held
transmitter may automatically stop
transmitting. Continue to press and
hold the HomeLink button (note
steps 2 through 4 in the
“Programming” portion of this text)
while you press and re-press
(“cycle”) your handheld transmitter
every two seconds until the frequen-
cy signal has been learned. The indi-
cator light will flash slowly and then
rapidly after several seconds upon
successful training.

NOTICE

If programming a garage door open-
er or gate, it is advised to unplug the
device during the “cycling” process
to prevent possible motor burn-up.

Accessories

If you would like additional informa-
tion on the HomeLink Wireless
Control System, HomeLink compati-
ble products, or to purchase other
accessories such as the HomeLink®
Lighting Package, please contact
HomeLink at 1-800-355-3515 or on
the internet at www.homelink.com.

Advertising