AEG HC411520GB - Manual (Page 32)

Before the installation, note down the serial number (Ser. Nr.) from the rating plate.The
rating plate of the appliance is on its lower casing.
Made in Switzerland Qn (Hs): 5 kW
Butan: 329 g/h
AC 220-240 V 50/60 Hz
P<0,025 kW
Adjusted for: G20 2H 2E 2E - 20 mbar
Typ: 55 WOK 04 GA
Mod.: HC411520GB
Serie-Nr:
PNC: 941 560 809/00
PIN 0063CL3461
10
0063
WARNING!
The following instructions about installation, connection and maintenance must be carried
out by qualified personnel in compliance with standards and local regulations in force.
Gas Connection
Make sure that during the installation the appliance is not connected to electrical supply.
Disconnect the mains plug or deactivate the fuses. Disconnect the mains gas supply.
Make sure that there is a stop tap assembled between the gas supply of house and the ap-
pliance.
The settings for this appliance are located on the rating plate. The present settings for the
type of gas and gas pressure are on a sticker
Choose fixed connections or use a flexible pipe in stainless steel in compliance with the reg-
ulation in force. If you use flexible metallic pipes, be careful they do not come in touch with
mobile parts or they are not squeezed. Also be careful when the hob is put together with an
oven.
This appliance is not connected to an exhaust gas outlet. It must be connected in accord-
ance with the installation conditions that apply. Pay special attention to correct airflow.
Make sure that the gas supply pressure of the appliance obeys the recommended values.
The adjustable connection is fixed to the comprehensive ramp by means of a threaded nut
G 1/2". Screw the parts without force, adjust the connection in the necessary direction and
tighten everything.
1
2
3
1 End of shaft with nut
2 Gasket
3
Elbow
WARNING!
After installation always check the tightness of the connections using a soap solution. Nev-
er use a flame to check the tightness.
32 Installation