AEG HC411520GB User Manual
Page 37
2.
Put the appliances one at time on some soft surface, a blanket for example, with the
bottom side up.
3.
Put the seal stripe around the lower edge of the appliance along the outer edge of the
glass ceramic.
4.
Loosely screw the fixing plates into the appropriate holes in the protective casing.
5.
Put the first appliance in the worktop cut out. Put the connection bar in the worktop
cut out and push up half of the width against the appliance.
6.
Loosely turn in fixing plates from below on the worktop and on the connection bar.
7.
Put the subsequent appliance in the worktop cut out . Make sure that the front ends
of the appliances are on the same level.
8.
Tighten the fixing plate / retaining grip screws.
9.
Seal the gap between the worktop and appliances and between appliances with sili-
cone.
10. Put some soapy water on the silicon.
11. Press the rubber shape with some strength against the glass ceramic and move it
slowly along the space.
Installation
37