Newport Brass 29-52 - Manual (Page 2)

SHADE UP INSTALLATION
1
Preparing Wall Outlet (for shade up installation)
A. Check fit the light fixture base over outlet box to ensure cutout in wall will be covered
completely after installation.
B. Pull live, neutral and ground wire(s) out of electrical outlet box and through the center of
mount plate.
C. Thread mounting screws through mount plate and attach to outlet box.
D. Be sure mount plate is straight with notch located at the top, tab at the bottom and flush
with wall surface.
CAUTION: DISCONNECT POWER
Always shut off power when installing or repairing this, or any other
electric appliance.
FAILURE TO DO SO MAY RESULT IN SEVERE INJURY OR DEATH
Installation by a licensed electrical contractor recommended.
AMS-10-51
EN-2641
REV B
11/07/2013