Newport Brass 1-570 - Manual (Page 3)

Trim Installation
Utilizing 3/4” copper pipe, make connections between spout, valves & water supply.
See Figure 4.
Warning: To prevent severe damage to valve body, any solder/braze process must be
performed a min. of 4" from ports.
Apply thread sealant and insert a rubber WASHER (16) into each end of HOSE (15).
Attach one end of HOSE (15) to diverter OUTLET (14). Pull other end through deck
FLANGE (18) and attach to hand SHOWER (19). Place hand SHOWER (19) into deck
FLANGE (18). See Figure 5.
Install ESCUTCHEON (21), place broached ROD (27) with o-ring onto STEM (22). Tighten
BONNET (26) over ROD (27) and onto ESCUTCHEON (21). Install LEVER (25) over
BONNET (26). Align & secure with SCREW (24). Press end CAP (23) with o-ring into
top of LEVER (25). Note: Any adjustments for rotational alignment must be made to
the valve BODY (2), not to the CARTRIDGE (22). Repeat for all handles. See Figure
6. (Cartridge Bonnet factory torque is 14-16 ft-lbs.)
Using a thin blade screwdriver, remove AERATOR (28) from SPOUT (8). Turn on water
supply, and flush both valves until water is clear. Check for leaks and make any final
adjustments required. Re-attach AERATOR (28) to the SPOUT (8). See Figure 7.
Figure 4
Inlet
for hot
water
supply
Inlet for cold
water supply
Figure 6
22
21
23 25
28
8
Figure 5
Figure 7
15
14
18
24
26
27
19
16
Note: Some states
require a ASSE 1016
approved Tempering
Valve installation with
this product. See the fol-
lowing disclaimer for
proper installation.
NWP-1-570