Prokit's Industries MT-7057 - Manual (Page 10)

9
are not installed in a wall or ceiling. Since both
ends are accessible, one end can be plugged
into the 4 in 1 Main unit, and one end into the
Remote unit. It is not necessary to remove the
Remote unit from its docked position on the
Main unit.
4. Testing Installed cables:
To test cables installed in ceilings or walls, or
in applications that prevent the ends from
being in the same location, the Remote can be
detached from the Main unit. Once detached,
the Remote can be attached to one end a
cable, and the Main unit attached to the other
to the other end of the cable. These ends are
often in different rooms and on different floors
of a building.
5. Performing the Test:
Once the Remote and Main unit are attached
to the ends of the subject cable, as described
in 6.3 and 6.4 ,testing may begin, simply press
and release the test button on the Main unit,
observe the LED indicators, and note the
beeping sound that comes from the Main unit.
6. Interpreting the Results:
6.1 Power LED:
The Power LED should light whenever the Test
Button is pressed and released. It will stay in
for a minimum of 5 seconds, or for however
long the Test Button is pressed. If the power
LED does not light, replace the battery.