Dowco Power Sports Guardian WeatherAll Plus Trike Cover - Manual

Installation
Read instructions before using.
Unfold cover and remove Warranty Card and foam
block from vent area. Locate “
FRONT” tag.
Position the front of the cover on motorcycle with
the vent positioned approximately over the seating
area. Starting in the front wheel area, pull down
over the windshield and “tuck” the elastic hem
under the centerline of the wheel.
Working toward the rear of the motorcycle, slide the
cover down the sides, avoiding “snag” points. The
cover should be long enough to allow the elastic
hem to fully wrap below the centerline of the rear
wheel and have a tight fit along the perimeter. Care
should also be taken to avoid placing the material
against hot engine components as melting or burn-
ing may occur.
Mirrors, muffler ends, shifters, brakes and foot
pegs are common wear points. Do not allow
fabric to “snag” around them. Antennas are
capable of puncturing the cover – use extreme
care.
Grommet patches are provided to enable you to
securely lock the cover under the motorcycle. A
cable lock or chain is recommended. However,
should you be unable to unlock the cover, it may
have to be cut through the hem and grommet area
to be removed.
Care and Cleaning
Your cover requires very little maintenance. Normal
dirt and grime should be brushed off with a soft terry
cloth or removed with warm water and a mild
detergent using a sponge or terry cloth. The cover
should be thoroughly dried before using.
Caution: Do not place in washing machine and do
not wring or twist the cover to remove moisture.
A water-repellant spray material, such as 3M
Scotchguard
® , is recommended for increased water
resistance.
Although protected with UV inhibitors, the fabric
may fade in direct sunlight after continuous use.
This is normal wear.
Important
Failure to comply with the above directions may
reduce the life of your cover. If you have any
questions or comments, please contact either your
dealer or DOWCO Inc.
Congratulations on your purchase of a GUARDIAN ® WEATHERALL ™ PLUS trike cover. Properly cared for,
your cover will last for many years of service. Your GUARDIAN ® WEATHERALL ™ PLUS trike cover is man-
ufactured from a heavy-weight polyester coated fabric which has excellent water and weather resistance
and may be used either inside or outside. Your cover also contains an elastic shock cord that is sewn into
a continuous hem. This feature eliminates the need for tie-downs. The integral vent allows moisture to
escape. The following information should be used to ensure maximum longevity.
This cover is not designed for covering your motorcycle while it is trailered or in the back of a
pick-up truck.
INSTRUCTIONS FOR THE INSTALLATION OF
GUARDIAN
® WEATHERALL ™ PLUS TRIKE COVER
Form # 141411-00
Revised 05/05
Printed in China
4230 Clipper Drive Manitowoc, WI 54220 U.S.A.
Phone: (800) 558-7755 - Fax: (920) 682-5891
Visit our Web Site! - www.dowco-inc.com
In severely windy conditions, “ballooning” of the cover may occur, which may result in the wind causing
the motorcycle to tip over. It is strongly recommended that your motorcycle be sheltered whenever high
winds are expected. If sheltering is not an option, facing into or rearward of strong gusts may reduce the
potential for wind damage. Attaching a bungee cord or cable through grommet areas may also help pre-
vent “ballooning” in high winds.