Neutrik opticalCON Coupler - Manual (Page 3)

NEUTRIK
B. General Overhaul
If increased attenuation cannot be reduced with dry cleaning (section A), a general overhaul is recommended.
The following cleaning procedure is carried out on the example of an opticalCON DUO coupler.
3
MAINTENANCE I opticalCON Coupler
R
1.
2.
3.
4.
Attention:
Untighten screws on both opticalCON chassis
with a screw driver.
Remove top and bottom shelf of metal housing
to release the protection tube.
Further slide colored protection tube towards
to one of the chassis.
Carefully disconnect the LC (MTP - ferrule)
on the rear-side of the opticalCON chassis.
Do not bend the fibers too much.
Enhanced risk of macrobending!
®
3.
1.
NEUTI
2.
2.
4.