Neutrik NPP-TB PATCH PANEL “Easy Patch” | 48 TB Jack - Manual (Page 5)

Page 5 of 11
NPP-TB Instruction Manual
3. Wiring
Wire are connected to WAGO spring clamping
devices. There is NO soldering or screwing
necessary. Simply insert the stripped wire (6 mm)
after pressing down the white key by means of a
screwdriver.
Lettering above the insertion holes:
T ... means TIP, R ... is RING and S ... is SLEEVE.
The corresponding channel numbers are located
adjacent to the WAGO terminals.
The terminal will handle solid and stranded wire up to
AWG 20 (0.5 mm²). Single wires up to AWG 18
(0.75 mm²) are possible.