Dexter Laundry T-30X2 EXPRESS - 60 Hz Gas (On-Premise) - Manual (Page 23)

23
SERVICING THE DRYER
CAUTION: Label all wires prior to disconnection when servicing controls. Wiring errors can cause
improper and dangerous operation. Verify proper operation after servicing.
ATTENTION: Lors des opérations d'entretien des commandes, étiqueter tous les fils avant de les
déconnecter. Touteerreur de câblage peut être une source de danger et de panne.
DRYER PREVENTIVE MAINTENANCE (PM) REQUIREMENTS
MAKE SURE ALL POWER IS DISCONNECTED BEFORE SERVICING
MACHINE
DAILY
1. Clean lint screen using a soft brush if necessary. Check lint screen for rips or tears and replace if
damaged.
MONTHLY
1. Clean lint from motor end bells and dryer controls area.
2. Clean lint from lint screen compartment.
3. Clean lint accumulation from top and all areas above, around and below burners and burner
housing. Failure to keep this section of dryer free from lint can create a fire hazard.
SEMI-ANNUALLY
1. Check V-belts for cracks, wear, fraying, or looseness.
2. Inspect all fasteners (screws, bolts, nuts, etc.) and tighten any that are loose.
3. Clean all lint accumulation from inside of front panel.
4. Place a few drops of light oil on top and bottom pivots of the door hinge.
5. Inspect door glass gasket for excessive wear.
6. Clean lint accumulation from the burner primary air ports.
7. Check intermediate drive pulley bushings for excessive wear.
ANNUALLY
1. Remove, inspect and clean main burner orifices of obstructions or dirt.
2. Grease intermediate drive pulley bearing at zerk grease fitting.
3. Inspect and remove any lint accumulation in the exhaust ducts. Inspect all ducting from the
dryer exhaust connection to the exit wall or roof.
4. Check tumbler shaft retaining nut for 125 lb-ft torque.
Contact Information:
Address: Dexter Laundry Inc., 2211 W. Grimes Ave., Fairfield, IA 52556
Phone: 1-800-524-2954
Website: www.dexterlaundry.com
Maintenance Notes: