Factory Direct Hardware Belle Foret N13001 - Manual (Page 3)

8
7-1
7-2
5
5
Wrap spout connector inlets with pipe tape, and connect to valve
bodies with flexible spout connector hoses.
Installation
6
Install handles.
7
Wrap valve body inlets with pipe tape and connect to water supply.
8 After attaching supply lines, remove aerator and turn on hot and cold
water for 1 minute to flush the lines. Replace aerator. Check for
leaks.
Steps 5-8
Valve body
Valve body inlet
Cross handle
Valve body inlet
Cap
Screw
Supply tube
Aerator
Spout connector
6
Pipe tape
Spout connector hose