Braun 3390 Silk-épil SoftPerfection - Manual (Page 13)

13
the comb tips against the hair
growth as shown in illustration B 5.
N.B. As hair does not always grow in
the same direction it may be difficult
to cut. In which case, guide the
appliance slightly diagonally or in
different directions.
Cleaning the shaver head
6. After shaving, unplug the appliance
and, if necessary, remove the
OptiTrim attachment.
7. Clean the OptiTrim attachment with
the brush.
8. In order to clean the shaver head,
remove the shaving foil frame .
To do so, press the release bars
on the front and back and pull it off.
9. Carefully tap the shaving foil frame
on a flat surface.
10. Brush out the cutter block as well
as the area below the cutter block.
11. N.B.: The shaving foil is a very
delicate part that must not be
cleaned with the brush.
12. We recommend that you put a drop
of light machine oil along the length
of the trimmer every 3 months.
13. Put the shaving foil frame back on
and snap it into place.
14. Replace the OptiTrim attachment
because it also serves as a
protective cap.
Note: Do not use the shaver head with a
damaged shaving foil.
Replacing the shaving parts
The shaving foil and the cutter block are
precision parts that wear out with the
time. Have the shaving foil frame and
the cutter block replaced when you
notice a reduced shaving performance
even after cleaning the shaver head.
Subject to change without notice.
This product conforms to the
EMC-Requirements as laid
down by the Council Directive
89/336/EEC and to the Low Voltage
Regulation (73/23 EEC).
8b
8c
8d
5319423_S6-92 Seite 13 Freitag, 14. November 2003 12:10 12