Buyers 09001023 - Manual (Page 4)

Quality since 1946

9049 Tyler Blvd. • Mentor, Ohio 44060
Phone (440) 974-8888 • Fax (440) 974-0165
Toll-Free Fax 800-841-8003 • buyersproducts.com
3007220 Rev. A
WarranTy
Buyers Products Co. warrants all truck/trailer hardware manufac-
tured or distributed by it, to be free from defects in material and
workmanship for a period of one year from date of shipment. Parts
must be properly installed and used under normal conditions. Any
product which has been altered, including modification, misuse,
accident or lack of maintenance will not be considered under
warranty. Normal wear is excluded. The sole responsibility of
Buyers Products Co. under this warranty is limited to repairing or
replacing any part or parts which are returned, prepaid, and are
found to be defective by Buyers Products Co. Authorization from
Buyers Products Co. must be obtained before returning any part.
No charges for transportation or labor performed on Buyers’ prod-
ucts will be allowed under this warranty.
19. To install the Safety Chain Mounting Kit (part no. BRB03
not included), it is necessary to drill four 3/4" holes through
the truck bed floor. Review and follow the Installation
Instructions for part no. BRB03 prior to installation of the
Safety Chain Mounting Kit. Locate the four safety chain kit
holes (marked “D” on the cutting template) in the front cross
member. From inside the truck bed drill one hole in truck
bed, in the center of each of the four mounting holes (“D”).
From inside the truck bed, install the two U-Bolts, as shown
in Fig. 3. From the underside of the truck, install four 5/8"
SAE flat washers, four compression springs and two 5/8"
center locking jam nut. Tighten all four 5/8" jam nuts until
two full bolt threads protrude below the jam nut.
Make cer-
tain the U-bolts pass through the G9003/G9005, truck bed
and the front cross member.
Fig. 3
Installation of Safety Chain U-Bolts