System requirements, Eeprom utilization – Ocean Optics QE Pro Install User Manual

Page 9

Advertising
background image

1: Introduction

891-00000-000-02-201401

3

•

LED indicator to show when the TEC is stable and accurate

•

Temperature stability: <0.1ºC

•

Continuous TEC setpoint control from 40ºC below ambient up to 50 ºC

• GPIO

•

Single strobe

•

Continuous strobe

•

10 user-programmable digital I/O pins

•

SPI/I2C for controlling peripherals

• Nonvolatile storage

•

Wavelength calibration coefficients

•

Linearity correction coefficients

•

Absolute irradiance calibration (optional)

• Buffering
• Triggering (4 modes)
• Resets

•

Watchdog timer for reliability

•

Hardware power recycle via reset pin or software command

• Kensington

®

security slot

• LEDs for feedback on TEC readiness and general spectrometer health
• Software support:

•

OceanView

•

OmniDriver

•

SeaBreeze

• CE certification

System Requirements

You can use the QE Pro’s USB connectivity with any computer that meets the requirements for the
spectrometer operating software being used (Windows XP/Vista/Windows 7, Mac OS X and Linux). See

About Ocean Optics Software

.

Alternately, the QE Pro has a serial port for connecting to PCs and PLCs. However, this connection
method requires an external power supply to power the QE Pro, the Breakout Box, and a serial cable.

EEPROM Utilization

Nonvolatile memory in each QE Pro contains wavelength calibration coefficients, linearity coefficients,
and a serial number unique to each individual spectrometer. The OOI software application reads these
values directly from the spectrometer, enabling the ability to “hot-swap” spectrometers between
computers without entering the spectrometer coefficients manually on each computer.

Advertising