SENA Parani100 - Manual (Page 31)

- 31 - 31
- At first, the Parani10 that you connected will be shown in the FROM column and then
Parani10 that you connected to Parani100 will be shown in the TO column like below.
(Using Parani100 manager)
- Press [Stop] button and [Done] button.
- Press [Disconnect] button in the connection window of Parani10 Manager.
* NOTE: Using Serial Hub mode is not limited to connections with the Parani10,
you may also use similar techniques with any Bluetooth Device that supports
the Serial Port Profile (SPP), please refer to your Bluetooth Devices
documentation on similar connection techniques as discussed above.