SENA ProBee-ZU10 - Manual (Page 61)

61 ProBee-ZU10 User Guide Rev.1.5
Execute ATS37?<CR> ATS37=<value><CR>
Response
<value><CR>
OK<CR>
OK<CR>
Default 0
Range 0 – 7
7.3.8 S38
Description
Get/Set the receive message mode. If it is enabled, a local node will receive multicast
or broadcast messages from itself.
Execute ATS38?<CR> ATS38=<value><CR>
Response
<value><CR>
OK<CR>
OK<CR>
Default 0
Range 0 – 1
7.3.9 S39
Description
Get/Set the receive mode. If S39 is enabled, a local node will only receive the same
type of messages with its transmission mode. For example, if local node’s
transmission mode is broadcast mode (AT+TM=3), it will receive only broadcast
messages and won’t receive unicast or multicast messages.
Execute ATS39?<CR> ATS39 =<value><CR>
Response
<value><CR>
OK<CR>
OK<CR>
Default 0
Range 0 - 1
7.4 End-Device
7.4.1 S51
Description
Get/Set the poll timeout for a parent node in seconds. If an end-device or a sleepy
end-device does not send a poll request to its parent coordinator or router within the
poll timeout, the end-device is removed from the child table.
Execute ATS51?<CR> ATS51=<value><CR>
Response
<value><CR>
OK<CR>
OK<CR>
Default 60
Range 0 – 4177920
7.4.2 S52
Description Get/Set the sleepy end-device poll period in milliseconds. Adaptive polling may allow