Full at commands set – SENA Parani10 User Manual
Page 40
40
Description :
Once paired, your PARANI10 uses the stored link key. By using this AT
command, you can make Bluetooth connection with a new link key. When n is
set to 1, your PARANI10 newly generates a link key during connection
process.
AT+UARTCONFIG, baudrate, parity, stopbit,handshaking<cr>
Function :
Configure the serial port of your PARANI10.
Response :
<cr><lf>OK<cr><lf>
Description :
By using this AT command, you can reconfigure the serial port of your
PARANI10. You can set baudrate, parity, stopbit . To make this command
result active, you should do soft-reset or turn off/on your PARANI10. The
following values are permitted for each parameter.
•
Baudrate = 1200, 2400, 9600, 19200, 38400, 57600 or 115200.
230400 (only for Parani10)
•
Parity = N (No parity), E (Even parity) or O (Odd parity).
•
Stopbit = 1 or 2.
•
Handshaking = 1 or 0
(If ‘1’, hardware handshaking will be used. If ‘0’, handshaking function of
Parani10 will be turned off)
Full AT commands set
No.
Command
Response
Comments
1)
AT<cr>
<cr><lf>OK<cr><lf>
2)
ATZ<cr>
<cr><lf>OK<cr><lf>
Drops all connections, disable Inquiry
and Page scans. Reset the Bluetooth
module.
3)
AT&F<cr>
<cr><lf>OK<cr><lf>
Reset to factory default state
4)
AT+BTINQ?<cr>
<cr><lf>112233445
5,FriendlyName,Co
D<cr><lf>
<cr><lf>112233445
5,FriendlyName,Co
D<cr><lf>
<cr><lf>112233445
5,FriendlyName,Co
Inquiry nearby devices. The OK at
the end means end of inquiry.