Billet Specialties Premium Tru Trac Serpentine System - Big Block Ford - Manual (Page 11)

www.billetspecialties.com
Figure 6: Install Bridge Bracket
Apply anti seize to three 5/16-18 x 1” flat head cap screws, one 5/16-18 x 1-1/2” flat head
cap screw and one 3/8-16 x 1” flat head cap screw.
(A) Place bridge bracket up to motor and align with mounts. Thread one 3/8-18 x 1” flat
head cap screw through driver side bottom bridge bracket and into water pump boss,
finger tighten. (B) Follow by threading the 5/16-18 x 1-1/2” flat head cap screw through the
bridge bracket and tensioner and into the lower spacer nut and finger tighten. (C) Finish
the installation by threading the remaining three 5/16-18 x 1” flat head cap screws into the
top three spacer nuts and finger tighten each one.
(D) Apply anti seize to the 5/16-18 x 1” socket head cap
screw and thread through the timing cover and into the
spacer nut attached to the tensioner, finger tighten.
11
(A)
(C)
(D)
(B)