Billet Specialties Premium Tru Trac Serpentine System - Big Block Ford - Manual (Page 8)

(A)
(B)
(C)
(D)
Figure 3a: Prepare Water Pump For Installation
(A) Install supplied water pump to manifold nipple and (B) heater hose barbed fitting or
block-off if heater is not being used.
(C) Apply Permatex Hylomar® gasket dressing to both sides of water pump gasket. Slide
gasket over studs and position.
(D) Slide water pump over studs.
Thread the three 2-3/16”
spacer nuts with the hex
end out onto the top three
exposed studs and finger
tighten. Follow by threading
the 1-5/8” spacer nut with the
hex end out onto the
remaining exposed stud
(bottom passenger side) and
finger tighten.