Billet Specialties Premium Tru Trac Serpentine System - Small Block Ford - Manual (Page 11)

www.billetspecialties.com www.billetspecialties.com
21
Figure 16: Install Bridge Bracket (Continued)
Apply anti seize to 8mm-1.25 x 40mm flat head cap screw and thread through
bridge bracket and upper tensioner hole and into spacer nut finger tighten.
Apply anti seize to 8mm-1.25 x 25mm flat head cap screw and thread into lower
hole finger tighten. (A)
Figure 15: Install The Bridge Bracket
Place bridge bracket on motor and align.
Apply anti seize to the two 8mm-1.25 x 25mm ARP 12pt. bolts and thread into
bottom passenger side holes and finger tighten. (A)
Thread one 8mm-1.25 x 25mm ARP 12pt. bolt through bridge bracket and into the
A/C compressor bottom boss and finger tighten. (B)
At this time swing the A/C compressor up and align top compressor boss with
bridge bracket. (C)
Thread one 8mm-1.25 x 25mm ARP 12pt. bolt through bridge bracket into top
A/C compressor boss and finger tighten. (D)
(A)
(B)
(C)
(D)
(A)