Mustang Motorcycle Seats One-Piece Deluxe DayTripper Seat - Harley-Davidson Softail - Manual (Page 3)

Mounting Suggestions
Harley-Davidson® Softail 1984-99
Two-Piece Seat
Baseplate Features:
Seats are built on 16 gauge formed steel baseplates. The baseplates
have rubber supports at contact points. Rear seat features carpet to
protect the fender.
NOTE: Mustang Softail seats will fit all Softail models except
1999­earlier FLSTS Heritage Springers.
Removal of Stock Seat
1. Remove the side mounting bolt on each side of driver’s seat.
2. Remove rear fender screw.
3. Remove seat from bike by sliding it up and back.
Mounting of Mustang Seat
1. Remove two 1/4‐20 screws in the rear of the Mustang solo baseplate.
2. Align passenger seat front chrome tabs with threaded holes in back of solo baseplate.
3. Secure passenger seat and solo together with screws from step 1. Seat becomes a one‐piece
unit.
4. Clip welded nose tab of solo into the frame mount behind the gas tank and secure passenger
seat tab with stock screw in rear fender.
5. Align the solo side brackets and attach with large Allen screws. NOTE: The solo side brackets
can be removed (and not used) when mounting the solo and passenger seat combination.
NOTE: Nylon washer should be under the rear bracket only on ‘95 and earlier models.
Mustang passenger seat can only be mounted to a Mustang solo seat.
These steps are guidelines to help you install your new Mustang Product. If you need further
assistance, please call us at 800‐243‐1392 or 860‐582‐9633, Monday through Friday 9:00 – 5:30
Eastern or send an e‐mail to
[email protected] or visit our website at
www.mustangseats.com .
For care and maintenance of our seats, please go to our website under “Support” .
Refers to part numbers 75122, 75123, 75141, 75142, 75490, 75492, 75506, 75509, 75512, 75513, 75514,
75750, 75751, 75757, 75764, 79104, 79114, 79124, 79134 ,79228, 79229, 79248, 79249
back