Mustang Motorcycle Seats Cyclone Hardware Kit 1997-2013 FL Air Ride - Manual (Page 3)

Stock seat removal
1. Unscrew three bolts from bottom of stock seat. These bolts will not be used
with the Mustang solo seat.
2. Remove stock seat from the pivoting bracket.
Mustang seat installation
1. Position solo seat onto pivoting
bracket.
2. Insert the two ¼‐20 x ¾” long hex
head bolts with washers into the rear
mounting holes in the pivoting
bracket and into the seat baseplate.
3. Insert the ¼‐20 x 2” long hex head
bolt with washer into the front or
nose mounting hole in the pivoting
bracket and into the seat baseplate.
4. Tighten all three bolts and pivot seat into riding position.
Mounting Suggestions
Harley‐Davidson® Police Air‐Ride 2008‐10
Cyclone Solo Seat
Hardware Kit HKSTCBC ‐ #78998 includes the following:
(2) ¼‐20 x ¾” long hex head bolts (1) ¼‐20 x 2” long hex head bolt
(3) 5/16” flat washers
These steps are guidelines to help you install your new Mustang product. If you need further
assistance please call us at 860‐582‐9633, Monday through Friday 9:00 ‐ 5:30 Eastern or send an
email to
[email protected] or visit our website at www.mustangseats.com
For care and maintenance of our seats, please go to our website under “Support” .
Ref: Cyclone Solo Seat part #’s 76615, 76616, 76617, 76618, 76621