SCANTECH ID (Champtek company) Scan Kiosk SK-40 - Manual (Page 9)

6
5
Spanish:
El SK-40/50 reune las normas de seguridad IEC 825-1 (1993) para un producto laser de Clase 1. Y también reune las
normas U.S. 21CFR1040 que se aplican a un producto laser de Clase IIa. Se debe evitar mirar muy fijo en luz lasérica
directa.
English:
The SK-40/50 complies with safety standard IEC 825-1 (1993) for a Class I laser product. It also complies with U.S.
21CFR1040 as applicable to a Class IIa laser product. Avoid long term viewing of direct laser light.
Optical:
The use of optical instruments with this product will increase eye hazard. Optical instruments include binoculars,
microscopes and magnifying glasses but do not include eyeglasses worn by the user.
Radiant Energy:
The SK-40/50-Omni uses a low-power laser diode operating at 630…670 nm in an opto-mechanical scanner resulting
in less than 0.6 mW peak output power. Laser light observed at 13 cm (5.1 in.) above the window through a 7 mm (0.28
in.) aperture and averaged over 1000 seconds is less than
3.9 µW per CDRH Class IIa specification. Do not attempt to remove the protective housing of the
scanner, as unscanned laser light with a peak output up to 0.8 mW could be accessible inside.
Laser Light Viewer:
The scanner window is the only aperture through which laser light may be observed on this product. A failure of the
scanner motor, while the laser diode continues to emit a laser beam, may cause emission levels to exceed those for
safe operation. The scanner has safeguards to prevent this occurrence. If, however, a stationary laser beam is emitted,
the failing scanner should be disconnected from its power source immediately.
Adjustments:
Do not attempt any adjustments to or alteration of this product. Do not remove the scanner’s protective housing. There
are no user-serviceable parts inside.
CAUTION
Use of controls or adjustments or performance
of procedures other than those specified herein
may result in hazardous laser light exposure.
CAUTION
Risk of Explosion if Battery is replaced by
an incorrect Type. Dispose of Used Batteries
According to the regular Instructions