SCANTECH ID (Champtek company) LIBRA L-7050 - Manual (Page 17)

LIBRA L-7050
11
Changing the interface cables
By default, a USB cable is already attached to LIBRA upon receiving it. To
change the interface connection, follow the steps below:
1. Hold the LIBRA upside down.
2. Remove the attached cable.
3. Connect the desired interface cable to LIBRA.
Wall hooks
4. Align the cable through the cable hook.
5. Connect the other end of the interface cable to your host system.
6. If necessary, mount the scanner on the wall using the wall hooks.
2.3 ADJUSTING
LIBRA
‟s angle can be adjusted. To do this, hold LIBRA by its back and adjust
the angle as shown below.
Front angle: 22° (max) / Back angle: 80° (max)