Q-Tech QT606L - Manual

THIS DOCUMENT IS CONSIDERED PROPRIETARY TO Q-TECH CORPORATION
DO NOT COPY OR DISTRIBUTE WITHOUT Q-TECH CORPORATION APPROVAL
51774 A
SHEET 1 of 5
CAGE CODE SIZE SCALE:
NONE
9/19/12 Peter Steinblums
DATE RELEASED BY
REV.
C
DRAWING NO.
QT606L
9/17/12 Minh Dao
DATE CHECKED BY
HYBRID CRYSTAL OSCILLATOR +3.3V, CLASS S,
DETAIL SPECIFICATION FOR
9/17/12 Curtis Hooper
DATE PREPARED BY
UNLESS OTHERWISE
SPECIFIED DIMENSIONS ARE
IN INCHES.
TOLERANCES:
3 PLACE DECIMAL = .005
2 PLACE DECIMAL = .02
1 PLACE DECIMAL = .1
FRACTIONS = ± 1/16
ANGLES = 2 DEGREES
Q-TECH CORPORATION
10150 W. JEFFERSON BLVD.
CULVER CITY, CA. 90232-3510
SPECIFICATION CONTROL DRAWING
C. Albright 9/19/12
Change IC for use of AC191 in paragraph 3.3.3.1, Table II maximum voltage, Table III
frequency range and tr/tf.
C
E.Jackson 8/08/08
Change to microcircuit manufacturer, paragraph 3.3.3. Remove tight duty cycle option.
Update frequency range, Table III.
B
E.Jackson 1/7/08 Corrections to Table III; add Table IV for tight duty cycle option. A
Initial release -
APPROVED DATE DESCRIPTION REVISION
REVISIONS
ITAR-CONTROLLED Q-TECH PROPRIETARY DO NOT COPY OR DISTRIBUTE WITHOUT Q-TECH APPROVAL