Q-Tech CLASS B+ - Manual (Page 12)

Q-TECH Corporation - 10150 W. Jefferson Boulevard, Culver City 90232 - Tel: 310-836-7900 - Fax: 310-836-2157 - www.q-tech.com
12 of 27
Q-TECH
CORPORATION
QPDS-0001, Rev L, June 2013 (ECO #10851)
CLASS B+ PRODUCTS
HIGH RELIABILITY HYBRID CRYSTAL CLOCK OSCILLATORS
2.5 to 5.0Vdc - 15kHz to 350MHz
Test Description
MIL
Standard Method Condition Qty
Comments
Internal Visual 883 2017 Class H 100%
Stabilization Bake 883 1008 C 100% 48 hours at +150°C
Seal Fine and Gross Leak 883 1014 A1, C 100%
Final Electrical Refer to Table IV-a and Detail Specification 100%
Frequency vs. Temperature Stability 55310
Measure output frequency at
10 equispaced points
minimum of the specified
operating temperature range
100%
External Visual 883 2009 100%
Screening Option E (Engineering Model)
(Example: QT122HCD9E-16.000MHz)
Parameters
Final
at 25ºC
Final
Low Temp
Final
High Temp
Output frequency ✓ ✓ ✓
Frequency/temperature stability ✓ ✓ ✓
Frequency/voltage stability ✓ ✓ ✓
Input current ✓ ✓ ✓
Output voltage ✓ ✓ ✓
Waveform ✓ ✓ ✓
Duty cycle ✓ ✓ ✓
Rise and fall times ✓ ✓ ✓
Start up time ✓ ✓ ✓
Tristate Function (if applicable) ✓ ✓ ✓
Table IV-a
Electrical Test – Measurement Requirements
Table IV
Engineering model oscillators will have the same design and manufacturing processes as to the flight units. Finished units will be
tested over the operating temperature range. No screening test and/or QCI are required.
Back To Summary