Q-Tech QTV706 Sine Wave User Manual
Page 7
QTV704, QTV705 and QTV706
DDIP Sine-Wave
REV.
Q-TECH Corporation
10150 W. Jefferson Blvd.
Culver City, CA 90232
SIZE
A
CAGE NO.
51774
Sheet 7 of 7
1.0
Q-TECH
PART NUMBER
FREQUENCY
.300 MAX.
24X .200 MIN.
24X Ø .018 ± .002
1.100
1.280 MAX.
.600
.790 MAX.
22X .100
NON-ACCUMULATIVE
ESD SYMBOL
FOR PIN No. 1
USA
D/C
S/N
1
12
24
13
▀
PART NUMBER GENERATION
SERIES
Output type and supply
voltage
TEMPERATURE RANGE (°C)/ Max. Overall
Stability/ Min. Frequency Pulling and Voltage
Control Range
Level
FREQUENCY
(MHz)
4: SINE WAVE +3dBm …..5V
N: 0.....+50°C ±25 ppm
±50 ppm Vc=0.5..4.5V
E: Eng. Model
10……150
5: SINE WAVE +7dBm ….12V
P: 0.....+70°C ±35 ppm
±70 ppm Vc=0.5..6.0V M: Flight Model
6: SINE WAVE 7dBm …..15V
Q: 20…+70°C ±40 ppm
±80 ppm Vc=0.5..6.0V
R: 40…+85°C ±45 ppm
±90 ppm Vc=0.5..6.0V
U: -55.+125°C ±65 ppm
±130 ppm Vc=0.5..6.0V
QTV70:
24 Pin
Double
Dip
(See note 1 below)
1. Variations from standard specification are available, please contact factory.
EXAMPLE:
QTV705URM-100.000000
would be a Flight Model version VCXO, 24 pin Double Dip, sine-wave 12 volts, overall
frequency stability (including Operating Temperature, ±5% Load Change, ±5% Supply Voltage change, 10 year aging,
and radiation)±45 ppm over -40…+85°C, @ 50 MHz with frequency pulling range from minimum of 90 ppm below center
frequency at 0.5V to a minimum of 90 ppm above center frequency at 6V.
.
QTV705URE-100.000000
would be a Engineering Model version VCXO, 24 pin Double Dip, sine-wave 12 volts, overall
frequency stability (including Operating Temperature, ±5% Load Change, ±5% Supply Voltage change, 10 year aging,
and radiation)±45 ppm over -40…+85°C, @ 50 MHz with frequency pulling range from minimum of 90 ppm below center
frequency at 0.5V to a minimum of 90 ppm above center frequency at 6V.
FIGURE 1 INTERFACE CONTROL DRAWING
24 Pin Double Dip
PIN NO.
DESIGNATION
1
Voltage Control
2 - 11
NC
12
Ground/Case
13
RF Output
14 - 23
NC
24
Supply Voltage
NOTES:
•
Dimensions are in inches.
•
Lead numbers are for reference only and
are not marked on the unit.
•
A triangle symbol is marked on the
corner of the package to indicate Pin 1.
•
All pins with NC function may not be
connected as external tie or connections
(pins may be connected internally).