QTech Data Systems EP1 Q03 Programming Dongle - Manual (Page 5)

EP1 – Q03 Programming Dongle - Quick Start Guide – v1.2 – 10 September2010 5
Figure 1 – Layout of the Q03 Revision D Processor
The location of the jumper positions is different for older Revision B and C Q03s.
Important Notes and Warnings
Anti Static
The Q03 Processor incorporates static discharge sensitive devices. Normal Anti
Static Discharge precautions should be employed when handling the Q03 Processor.
Q03 firmware earlier than IN180
Firmware earlier than IN180 does not support the saving or loading
of RTU configuration files by Q90. For these old versions of firmware, a manual
written note must be taken of all configurations before upgrading.
DATRAN II eXcel RTU display boards (Q24).
DATRAN Product Bulletin 2010-001outlines that care needs to be taken when
upgrading firmware prior to v5.01. A copy of the Bulletin is on the supplied CD. The
Q24 display board may also need upgrading. To simplify this, each EP1 is delivered with a
new Q24 display board in the packaging. This does not affect QRTU upgrades.
Reinstalling the RTU
When the upgrade is complete, the RTU will not have a DLP, the time (RTC) will not
be correct and it will not have any Data Logging configuration. Please remember
to transmit these from the base station, or use Q90, as soon as the RTU is reinstalled.