QTech Data Systems Tait TM8000 Radio - Manual (Page 28)

28 Basic operation
Ending all active calls
You may have a function key programmed to either end the
current call, or end the current call and all other active calls in
your group.
This can be done either by:
■ using the function key programmed for reset monitor to
end your current call,
■ using the function key programmed for call cleardown to
end your current call and all other calls in your group, or
■ using the function key programmed for both reset monitor
and call cleardown.
Ending your current call by using a function key
■ Press the function key programmed for reset monitor.
The radio’s monitor is turned off, ending your current call
and the green LED stops flashing.
Ending all active calls by using a function key
■ Press the function key programmed for call cleardown.
Monitor is turned off for all radios in your radio group. Any
call in progress or incoming call is ended and the green LED
stops flashing.
Ending active calls by using the function key
programmed for reset monitor/call cleardown
The function key programmed for reset monitor may be
programmed so that:
■ a short key press ends your current call, and
■ a long key press ends all active calls in your group.