GE Industrial Solutions A Series Lighting Control Panelboards Installation - Manual (Page 2)

2. Locate the interior end flange keyhole mounting holes to the corresponding mounting bolts already in
place on the inside surface of the panel enclosure as shown in Fig 1. Tighten all 4 screws
NOTE: The following assembly view shows
the panel interior as mounted to the
enclosure.
PANEL BOX
INTERIOR MTG
1 / 4 – 20 x 3 / 8
LONG SCREWS
QTY-4 (PROVIDED
WITH PANEL BOX)
CONTROLLER SECTION
DEAD FRONT
CONTROLLER ACCESS DOOR
INTERIOR
FRONT
Figure 1
- 2 -