GE Industrial Solutions Remote Racking Operator: Low Voltage EntelliGuard G Circuit Breakers - Manual (Page 2)

2
Section 1. Introduction
The remote racking operator allows the user
to move a draw out circuit breaker between
the CONNECT and DISCONNECT positions via
an electric racking gear head motor and the
Cassette housing the breaker. The remote
racking operator requires 115VAC, 60Hz
control power. A control box connected to the
operator with a thirty-foot chord permits
control from a remote location.
Section 2. Receiving, Handling and
Storage
2.1 Receiving and Handling
Each Remote Racking operator is carefully
inspected and packed for shipment.
Immediately upon receipt of the device an
examination should be made for any damage
sustained in transit. If injury or rough handling is
evident, a damage claim should be filed
immediately with the transportation company,
and the nearest General Electric Sales Office
should be notified.
The device should be removed from the shipping
box with sufficient care so that no damage will
result from rough handling. “Loose parts”
associated with the apparatus may be included
in the crate. Care should be taken to make
certain that these parts are not overlooked.
2.2 Storage
The remote racking operator should be
protected against condensation, preferably by
storing it in a warm, dry environment at
moderate temperatures such as 40 degrees F to
100 degrees F. The storage area should be clean
and contain no corrosive gasses.
If the device is stored for any length of time, it
should be inspected prior to use to insure its
proper mechanical and electrical working
condition.
WARNING: Danger of electrical shock or
injury. Ensure ALL electrical power
supplies are « OFF « before installing or
removing any devices. Ensure the breaker
is in the OFF position before racking from
the disconnected to connect position or
from connect to disconnect. The breaker,
trip unit or accessories MUST ONLY be
installed and serviced by QUALIFIED
personnel, see NEMA publication Ab4.
Avertissement : Danger de electrocution ou
de blessure. S
‘assurer avant TOUTES
manipulations du disjoncteur que les
differentes sources d’alimentation sont en
position «
OFF ». S’assurer que le
disjoncteur est en position « OFF » avant
montage dans la position branchee a partir
de la position debranchee et.ou mantage
dans la position de’branchee a’ partir de la
position branchee. Les disjoncteurs,
unites de protection ou accessoires
doivent etre installes par des personnes
qualiffees et habilitees. Voir NEMA
publication Ab4.