Installation of the drive in the enclosure – GE Industrial Solutions AF-650 GP Top & Bottom Cover Duct Kit - NEMA 3R User Manual
Page 9
Advertising
Instruction No: 177R0109 V1
May 7, 2009
Page 9
Figure 14. Bottom air inlet cover installed
Installation of the Drive in the Enclosure
Install the gasket material on the bottom
air inlet cover and install using 2-M5
screws as shown in Figure 14.
A drain hose may be attached to the drain
plug if there is concern that condensation
may accumulate in the bottom of the duct.
If not, plug the drain plug with a screw
provided with the kit. It is recommended
that Teflon tape be used with the screw to
seal the drain plug.
177R0109
July 15, 2009
DET-704, Page 9
177R0109
February 25, 2010
DET-704a, Page 9
Advertising