GE Industrial Solutions POWER LEADER ModBus Monitor - Manual (Page 65)

POWER LEADER Modbus Monitor
Appendix D – Supported Firmware Revisions for TID’s
59
The Modbus Monitor supports a variety of devices; however, each of these devices has had its own product
development cycle and undergone various revisions. Therefore, this appendix provides the firmware revision of each
device which has been tested with the Modbus Monitor and found to be compatible. Other firmware revisions may or
may not function with the Modbus Monitor. If you are concerned about compatibility of a device firmware revision,
contact the GE Resolution Center at 1-888-GE-RESOLV.
Device Device Firmware
Revision
Supported
POWER LEADER EPM (commnet communications option) 1.06
POWER LEADER EPM (Modbus communications option) 2.0/3.3
POWER LEADER Meter 2.0
EPM 3710 MOD3.0.1.0-B
EPM 3720 V05B1502
MULTILIN Power Quality Meter (PQM) 2.02
POWER LEADER MDP Overcurrent Relay (commnet communications option) 1.0
POWER LEADER MDP Overcurrent Relay (Modbus communications option) 2.0/3.3
Spectra MicroVersaTrip™ 5.12
Enhanced MicroVersaTrip™ C 4.13
Enhanced MicroVersaTrip™ D 4.13
Spectra ECM™ 7.2
MULTILIN 239 Motor Protection Relay 2.11
MULTILIN 269 Plus Motor Management Relay 5.2.1
MULTILIN SR469 Motor Management Relay 2.4.2
MULTILIN SR489 Generator Management Relay 32D120A8.000
MULTILIN 565 Feeder Management Relay 2.4
MULTILIN 735 Feeder Relay 1.0
MULTILIN SR745 Transformer Management Relay 2.10
MULTILIN SR750 Feeder Management Relay 3.30
MULTILIN SR760 Feeder Management Relay 3.30
System Monitor SM-3 Voltage Regulator 2.01
EPM 7300 1.33
Table 5. Device firmware revisions supported by the Modbus Monitor.
POWER LEADER Modbus Concentrator
The Modbus Monitor offers compatibility with commnet communications devices through the POWER LEADER
Modbus Concentrator (see GEH-6491 for details), which maps devices’ commnet addresses to an equivalent Modbus
address and routes Modbus network communications to and from the commnet devices attached to it. The Modbus
Concentrator firmware revision supported by the Modbus Monitor is 2.1.
Power Management Control System (PMCS)
The Modbus Monitor is compatible with GE Power Management and Control System version 5.1 or greater. Earlier
versions of PMCS are not compatible with the Modbus Monitor. It is also important to remember that not all devices
supported by the Monitor are supported by the PMCS 5.1 Server (although all devices supported by the Monitor are
supported by the PMCS 6.0 Server).