GE Industrial Solutions A Series Lighting Control Panelboards Programmer User Guide - Manual (Page 39)

A Series ® Lighting Controller LCD Programmer
Chapter 9 – Dimming Menu
35
Editing the 600/700 Series
Daylight Optimization Modules
The following procedures are used to edit the various
objects of these Daylight Optimization Modules.
Input Light Level
1. These objects can be edited by going to a
particular Light Level object (in the example
below it is 601) as explained above. Press
OK to
edit.
2. Press the A/M key to change to manual mode:
3. Press the numeric keys to set the desired value.
Press
OK to accept the changes.
4. To return the object (LTG LVL 601) to auto
mode, press
OK , followed by the A/M key, followed
again by OK .
5. Press the down arrow key to scroll to the Lighting
SP object.
Set Light Level
1. Scroll to the LTG SP object; the display will be
similar to the following:
2. Press OK to edit the settings:
3. Press the A/M key to switch to manual mode.
4. Use the numeric keys to set the desired value; in
this example, from 44.0 to 50.0:
5. Press OK to accept the change. Press OK again,
followed by the A/M key to return to auto mode:
6. Press OK to complete the switch to auto mode.
7. Press the down arrow key will scroll to the LTG OP
object.
Lighting OP
The Lighting OP value is automatically generated by
the feedback loop.
Setting Lighting Feedback Loop Gain
1. Scroll to the LTG PB object, and press OK:
Flashing
Flashing
Flashing
Flashing
Flashing
Flashing
Flashing