1 display node address (mac id), 2 display baud rate, 3 node status – GE Industrial Solutions 6KCV301DNET User Manual
Page 28: 2 display baud rate 6.2.3 node status, 1 devicenet error types
Advertising
GEI-100435A
——————
Interface card DeviceNet
——————
28
6.2.1 Display node address (MAC ID)
The node address (MAC ID), set by Dip-Switches, is displayed.
6.2.2 Display Baud Rate
The current Baud Rate of the node, set by Dip-Switches, is displayed.
6.2.3 Node status
The following node status are displayed:
·
DNet Status.
·
DNet StAux.
·
DNet StUser.
By pressing the ENTER key, these three error-conditions are set to zero.
In normal conditions all must be set to zero; when pressing th ENTER key, all
error conditions are set to zero; if after this, the values are different from zero,
it means that an error occurred; even if these states are different from zero, the
PLC Master may be connected anyway.
Advertising