GE Industrial Solutions EPM1500 Single Point Submetering System - Manual (Page 7)

CHAPTER 1: OVERVIEW
EPM 1500 SUB-METER – INSTRUCTION MANUAL 1–3
1.2.3 Interior View
The interior of the EPM 1500 is shown below.
FIGURE 1–2: Interior View of the EPM 1 500
Note Where the and symbols are seen on the EPM 1500 meter, the manual must be
consulted to determine the nature of any potential hazard and/or actions to be taken.
1.2.4 Cautions and Warnings
• Do not install if the device is damaged. Inspect the housing for obvious defects such
as cracks in the housing.
• If the device is installed or used in a manner not specified by accompanying
documents, the protection of the device may be impaired.
• If the device functions abnormally, proceed with caution. The protection of the device
may be impaired.
• Do not install the meter around combustible gas or gas vapor.
• Do not install the meter in an electrical service with current or voltage outside of the
specified limit of the device.
• Do not operate the meter with the cover removed.
• To avoid electric shock, disconnect mains before replacing fuses!
• See instructions for connection diagram.
• Risk of electric shock. Beware of working around this meter when the voltage is live.
• For continued protection against fire, replace only with fuses of specified voltage and
current rating.
709703A1.CDR