Asus AP1600R-E2(BI2) - Manual (Page 117)

A S U S A P 1 6 0 0 R - E 2 ( B A 2 / B I 2 ) A S U S A P 1 6 0 0 R - E 2 ( B A 2 / B I 2 ) A S U S A P 1 6 0 0 R - E 2 ( B A 2 / B I 2 ) A S U S A P 1 6 0 0 R - E 2 ( B A 2 / B I 2 ) A S U S A P 1 6 0 0 R - E 2 ( B A 2 / B I 2 ) 6 - 1 9 6 - 1 9 6 - 1 9 6 - 1 9 6 - 1 9
6.1.4.6 6.1.4.6 6.1.4.6 6.1.4.6 6.1.4.6 Rebuilding a RAID set Rebuilding a RAID set Rebuilding a RAID set Rebuilding a RAID set Rebuilding a RAID set
The utility displays the condition of the RAID set during the POST. When a
RAID set is degraded, you can use the utility to rebuild it.
To rebuild a RAID array:
1. Enter the Adaptec RAID Configuration Utility following the instructions
in the section “Creating a RAID 0 (Stripe).”
2. Select A r r a y C o n f i g u r a t i o n U t i l i t y A r r a y C o n f i g u r a t i o n U t i l i t y A r r a y C o n f i g u r a t i o n U t i l i t y A r r a y C o n f i g u r a t i o n U t i l i t y A r r a y C o n f i g u r a t i o n U t i l i t y from the initial menu, then
press <Enter>.
Check the physical connections of the SATA hard disk drives before you
rebuild a degraded RAID set. Check the system and motherboard user
guide for additional information.
3. From the main menu, highlight Manage Arrays, then press <Enter> to
display the installed RAID sets.
4. Highlight the degraded RAID set, then press <Enter> to display the
array properties. The A r r a y S t a t u s
A r r a y S t a t u s A r r a y S t a t u s A r r a y S t a t u s A r r a y S t a t u s shows DEGRADED.