Chapter 3 - software reference – Asus WL-130N User Manual

Page 20

Advertising
background image

20

ASUS WLAN Adapter

Chapter 3 - Software Reference

Chapter 3

So

ftw

are

R

efe

ren

ce

Data Encryption

For Open and Shared authentication mode, the configuration options of

encryption type are Disabled and WEP. For WPA-Enterprise, WPA-Personal,

WPA2-Enterprise and WPA2-Personal authentication mode, Temporal Key

Integrity Protocol (TKIP) encryption and Advanced Encryption Standard (AES)

encryption are supported.
Disabled - Disable the encryption function.
WEP - WEP Key is used to encrypt your data before it is transmitted over air.

You can only connect and communicate with wireless devices that use the

same WEP keys.
TKIP - TKIP uses an encryption algorithm methods which is more stringent

than the WEP algorithm. It also uses existing WLAN calculation facilities to

perform encryption. TKIP verifies the security configuration after the encryption

keys are determined.
AES: AES is a symmetric 128-bits block encryption technique which works

simultaneously on multiple network layers.

Wireless Network Key

This option is enabled only if you select WPA-Personal or WPA2-Personal

authentication mode. Note: 8 to 63 characters or 64 hexadecimal are required

in this field.

Wireless Network Key (WEP)

This option is configurable only if you enable WEP in Network Authentication

field. The WEP Key is a 64-bits (5 byte) or 128-bits (13 byte) Hexadecimal

digits which is used to encrypt and decrypt data packets.

Key Format

You can select to enter Hexadecimal digits (0~9, a~f, and A~F) or ASCII

characters to setup keys by defining the Key Format.

Key Length

For 64 bits encryption, each key contains 10 hex digits or 5 ASCII characters.

For 128 bits encryption, each key contains 26 hex digits or 13 ASCII characters.

Two ways to assign WEP keys

1. Manual Assignment - When you select this option, the cursor appears

in the field for Key 1. For 64-bits encryption, you are required to enter four

WEP Keys. Each Key contains exactly 10 hex digits (0~9, a~f, and A~F).

For 128-bits encryption, you are required to enter four WEP Keys. Each

Key contains exactly 26 hex digits (0~9, a~f, and A~F).

Advertising