Asus PIKE 2108 - Manual (Page 14)

1-6 Chapter 1: Product introduction
Uninstall ASUS PIKE 2108 SAS RAID card from the server system
1. Disconnect all SAS hard disk
drives from the motherboard.
2. Remove the screw that secures the
RAID card to the motherboard.
3. Release the heatsink latch from
the card slot with a finger, and then
remove the RAID card from the
slot.
If you have a LSI Battery Backup Unit
(BBU), connect the BBU cable to the
BBU connector on the PIKE RAID card.
Align the pin 1 wire (red) of the BBU
cable to the triangle mark on the BBU
connector, and then firmly insert the
cable.
Attach the Battery Backup Unit (BBU) cable