Asus RS720-E6/RS12 - Manual (Page 87)

ASUS RS720-E6/RS12 5-23
Onboard LAN1/2 Boot [PXE]
Allows you to configure the onboard LAN1/2 boot mode.
Configuration: [Disabled] [PXE] [iSCSI]
5.4.6 Power On Configuration
APM Configuration
Restore on AC Power Loss [Last State]
Resume On Ring [Disabled]
Resume On PME#(Wake On LAN) [Disabled]
Resume On RTC Alarm [Disabled]
BIOS SETUP UTILITY
Advanced
Options
Power Off
Power On
Last State
Restore on AC Power Loss [Last State]
When set to [Power Off], the system goes into off state after an AC power loss.
When set to [Power On], the system will reboot after an AC power loss. When set
to [Last State], the system goes into either off or on state, whatever the system
state was before the AC power loss.
Configuration options: [Power Off] [Power On] [Last State]
Resume On Ring [Disabled]
When set to [Enabled], the system will generate a wake event when the external
modem receives a call while the computer is in Soft-off mode.
Configuration options: [Disabled] [Enabled]
Resume On PME#(Wake On LAN) [Disabled]
When set to [Enabled], the system enables the LAN devices to generate a wake
event while the computer is in Soft-off mode.
Configuration options: [Disabled] [Enabled]
Resume On RTC Alarm [Disabled]
Allows you to enable or disable RTC to generate a wake-up event.
Configuration options: [Disabled] [Enabled]
The following items appear only when the Resume On RTC Alarm item is set
to [Enabled].
RTC Alarm Date [15]
To set the alarm date, highlight this item and press the <+> or <-> key to
make the selection.
System Time [12:30:30]
Use the <ENTER>, <TAB> or <SHIFT-TAB> key to select a field. Use the <+>
or <-> key to configure alarm time.