Asus ASMB3-iKVM - Manual (Page 21)

ASUS ASMB3-IKVM 2-5
2.3 Firmware update
You need to update the ASMB3-IKVM firmware before you start using the
ASMB3-IKVM board.
To update the firmware:
1. Insert the support CD into the optical drive.
2. Restart the remote server, then press <Del> during POST to enter the BIOS
setup.
3. Go to Boot menu and set the Boot Device Priority item to [CD-ROM].
4. When finished, press <F10> to save your changes and exit the BIOS setup.
5. On reboot, the main menu appears. Select ASMB3-iKVM Firmware Update,
and press <Enter> to enter the sub-menu.
6. A confirmation message appears, asking whether you want to update the
firmware or not. Press <Y> to update.
ASUS Server RS100-E5/PI2 System
FreeDOS command prompt
ASMB3-iKVM Firmware Update
Are you sure you want to update ASMB3-iKVM Firmware now?
Yes or No [YN]?
The firmware updating process starts.
7. When the update process is completed, the following screen appears.
Starting Firmware Upgrade
Uploading Firmware File
0% ------------------- 50% ------------------ 100%
Upload complete.
Flashing Firmware (takes about 1min)
Successfully upgraded firmware.
Press any key to continue ...
8. Turn off the system and unplug the AC power cord for 5 seconds before
restarting the system
You may update firmware from the web-based user interface. Refer to page 3-25
for details.