Asus MM17T - Manual (Page 6)

5
INSTALLATION INSTRUCTIONS
ASSEMBLING THE MONITOR BASE
Install Remove
Figure 1
POWER CORD / POWER SOURCE
1. Make sure that the power cord is the correct type required in your area.
2. This LCD monitor has an internal universal power supply that allows operation in either
100/120V AC or 220/240V AC voltage area (No user adjustment is required.)
3. Connect the power cord into your LCD monitor ’s power input socket, and then plug the
other end into a 3-pin AC power outlet. The power cord may be connected to either a wall
power outlet or the power outlet socket on your PC, depending on the type of power cord
supplied with your LCD monitor.
NOTES
A certified power supply cord has to be used with this equipment. The relevant national
installation and/or equipment regulations shall be considered. A certified power supply cord
not lighter than ordinary polyvinyl chloride flexible cord according to IEC 60227 (designation
H05VV-F 3G 0.75mm
2
or H05VVH2-F2 3G 0.75mm
2
) shall be used. Alternative a flexible cord
be of synthetic rubber according to IEC 60245 (designation H05RR-F 3G 0.75mm
2
) shall be
used.