Asus RS120-E5/S - Manual (Page 22)

Chapter 2: Hardware setup 2-4
2. Firmly hold the cover and slide it
toward the rear panel for about half
an inch until it is disengaged from
the chassis.
5. Lift the cover from the chassis.
2.1.3 Installing the top cover
1. Position the cover on top of the chassis with the thumbscrews on the rear,
and leave a gap of about half an inch from the front panel.
2. Make sure that the pegs on the cover (two on each side) are aligned to the
grooves on the chassis.
3. Slide the cover toward the front until it snaps in place.
4. Tighten the thumbscrews on the rear to secure the cover.
1/2 inch
distance
Pegs inside
Grooves
Thumbscrews