Asus K8U-X - Manual (Page 65)

ASUS K8U-X Motherboard 2-29
Make sure that the above item is set to [Enabled] if you wish to use the
ASUS MyLogo feature.
depends on the number of hard disk drives installed in the system.
Configuration options: [xxxxx Drive] [Disabled]
2.6.3 Boot Settings Configuration
Quick Boot [Enabled]
Enabling this item allows the BIOS to skip some Power On Self Tests
(POST) while booting to decrease the time needed to boot the system.
When set to [Disabled], BIOS performs all the POST items. Configuration
options: [Disabled] [Enabled].
Full Screen Logo [Enabled]
Allows you to enable or disable the full screen logo display feature.
Configuration options: [Disabled] [Enabled].
Add On ROM Display Mode [Force BIOS]
Sets the display mode for option ROM. Configuration options: [Force
BIOS] [Keep Current].
Bootup Num-Lock [On]
Allows you to select the power-on state for the NumLock. Configuration
options: [Off] [On].
PS/2 Mouse Support [Auto]
Allows you to enable or disable support for PS/2 mouse. Configuration
options: [Disabled] [Enabled] [Auto].
Wait for ʻF1ʼ If Error [Enabled]
When set to Enabled, the system waits for F1 key to be pressed when
error occurs. Configuration options: [Disabled] [Enabled].
Hit ʻDELʼ Message Display [Enabled]
When set to Enabled, the system displays the message “Press DEL to run
Setup” during POST. Configuration options: [Disabled] [Enabled].
Boot Settings Configuration Allows BIOS to skip
certain tests while
Quick Boot [Enabled] booting. This will
Full Screen Logo [Enabled] decrease the time
AddOn ROM Display Mode [Force BIOS] needed to boot the
Bootup Num-Lock [On] system.
PS/2 Mouse Support [Auto]
Wait for ‘F1’ If Error [Enabled]
Hit ‘DEL’ Message Display [Enabled]
Interrupt 19 Capture [Disabled]