Asus H81I-PLUS - Manual (Page 22)

1-14 Chapter 1: Product introduction
3. CPU and chassis fan connectors (4-pin CPU_FAN and 4-pin CHA_FAN)
Connect the fan cables to the fan connectors on the motherboard, ensuring that the
black wire of each cable matches the ground pin of the connector.
Do not forget to connect the fan cables to the fan connectors. Insufficient air flow inside
the system may damage the motherboard components. These are not jumpers! Do not
place jumper caps on the fan connectors! The CPU_FAN connector supports a CPU fan of
maximum 1A (12 W) fan power.
CPU_FAN
CPU F
AN PWM
CPU F
AN IN
CPU F
AN PWR
GND
H81I-PLUS
H81I-PLUS CPU and chassis fan connector
CHA_FAN
CHA
F
AN PWM
CHA
F
AN IN
CHA
F
AN PWR
GND
4. Intel ® H81 Serial ATA 6.0Gb/s connector (7-pin SATA6G_1~2 [yellow])
These connectors connect to Serial ATA 6.0 Gb/s hard disk drives via Serial ATA 6.0
Gb/s signal cables.
When using hot-plug and NCQ, set the SATA Mode Selection item in the BIOS to [AHCI].
SATA6G_1
GND
RSATA_TXP1
RSATA_TXN1
GND
RSATA_RXN1
RSATA_RXP1
GND
SATA6G_2
GND
RSATA_TXP2
RSATA_TXN2
GND
RSATA_RXN2
RSATA_RXP2
GND
H81
I-PLU
S
H81I-PLUS SATA 6.0Gb/s connectors