Asus RS300-E7/RS4 - Manual (Page 20)

Chapter 2: Hardware setup 2-2
2.1 Chassis cover
Removing the rear cover
1. Locate and remove the front side screws.
3. Firmly hold the cover and slide it
toward the rear panel for about half
an inch until it is disengaged from
the chassis.
4. Lift the cover from the chassis.
5. To recover the rear cover, reverse
step 1 to 4.
2. Loosen the two thumbscrews on the rear panel to release the rear cover from
the chassis.
Thumbscrews
A protection film is pre-attached
to the system cover before
shipping. Please remove the
protection film before turning
on the system for proper heat
dissipation.
Front side screw