Asus A8V-MX - Manual (Page 35)

A S U S A 8 V - M X A S U S A 8 V - M X A S U S A 8 V - M X A S U S A 8 V - M X A S U S A 8 V - M X 1 - 2 5 1 - 2 5 1 - 2 5 1 - 2 5 1 - 2 5
3 . 3 . 3 . 3 . 3 . I D E c o n n e c t o r s ( 4 0 - 1 p i n P R I _ I D E , 4 0 - 1 p i n S E C I _ I D E ) I D E c o n n e c t o r s ( 4 0 - 1 p i n P R I _ I D E , 4 0 - 1 p i n S E C I _ I D E ) I D E c o n n e c t o r s ( 4 0 - 1 p i n P R I _ I D E , 4 0 - 1 p i n S E C I _ I D E ) I D E c o n n e c t o r s ( 4 0 - 1 p i n P R I _ I D E , 4 0 - 1 p i n S E C I _ I D E ) I D E c o n n e c t o r s ( 4 0 - 1 p i n P R I _ I D E , 4 0 - 1 p i n S E C I _ I D E )
These connectors are for an Ultra DMA 100/66 signal cable. The Ultra
DMA 100/66 signal cable has three connectors: a blue connector for
the primary IDE connector on the motherboard, a black connector for
an Ultra DMA 100/66 IDE slave device (optical drive/hard disk drive),
and a gray connector for an Ultra DMA 100/66 IDE master device (hard
disk drive). If you install two hard disk drives, you must configure the
second drive as a slave device by setting its jumper accordingly. Refer
to the hard disk documentation for the jumper settings.
• Pin 20 on the IDE connector is removed to match the covered hole
on the Ultra DMA cable connector. This prevents incorrect insertion
when you connect the IDE cable.
• Use the 80-conductor IDE cable for Ultra DMA 100/66 IDE devices.
A8V-MX
¤
A8V-MX IDE connectors
NOTE: Orient the red markings
(usually zigzag) on the IDE
ribbon cable to PIN 1.
SEC_IDE
PIN 1
PRI_IDE
PIN 1