Asus ESC2000 Personal SuperComputer - Manual (Page 34)

Chapter 2: Hardware setup 2-14
2.6.3 Installing a hot-swap SATA hard disk drive
1. Release a drive tray by pushing the
spring lock to the right, and then
pulling the tray lever outward. The
drive tray ejects slightly after you
pull out the lever.
2.6.2 Removing the HDD module cage
1. Disconnect the all cables from the SATA backplane on the HDD module cage.
2. Level the HDD module cage latch
counterclockwise. The HDD module
cage will be pushed out of the
chassis.
2
3. Completely pull out the HDD module
cage.