Air Suspension C-2527 Rev 4 - Manual (Page 6)

6 C-2527 REV 4
03/07/14
FIGURE 10-2 FIGURE 10-3
3.0 Remove the upper insulator.
4.0 Remove the shock absorber mounting bolts at the lower control arm. Remove the
shock absorber through the lower control arm from below. (FIGURE 10-3)
Installation:
1.0 Support the lower control arm with a suitable jack in order to align the tennon with
the mounting hole if equipped with selectable ride.
2.0 Install shock absorber through the lower control arm from below .
3.0 Connect tennon through the mounting hole in the upper spring pocket .
4.0 Align the shock absorber with the mounting hole in the lower control arm.
5.0 Install shock absorber mounting bolt to the lower control arm. Tighten to 70 ft. lbs.
(25 Nm).
6.0 Connect upper insulator to the shock absorber . (FIGURE 10-3)
7.0 Install nut to the tennon end. Do not tighten the nut.
8.0 Remove the safety stands.