Mounting the weapon – Armasight NWWORION0411I11 ORION 4x GEN 1+ Night vision rifle scope User Manual
Page 5
5
MOUnTIng THE wEAPOn
1) Loosen the screws on the 7/8” weaver mount of the
Orion.
2) Place the sight on the weaver base of the firearm.
3) Re-tighten the screws.
nOTE:
After a round of firing the fixing screws may need to be re-tightened.
To provide you with greater flexibility when mounting your Orion on the mount system, we have in-
stalled a small rail with a fixing projection on the base of the mount bracket, together with the deter-
mined weaver rail indents that are used for mounting. The mount bracket has two grooves that can
accept this rail. You can shift the mounting position of your Orion by an extra 1/3 of an inch by simply
turning the rail around.
To add additional inches to the Orion weapon mount,
please follow the instructions below:
1) Remove the two screws that attach the rail to the
mounting bracket.
2) Remove the rail from the groove.
3) Turn the rail around.
4) Put the rail into the other groove.
5) Re-tighten the two screws on the rail.
nOTE:
Occasionally, you may find that the rail does not slide out easily. If this occurs, rotate one of the
removed screws into the threaded aperture in the center of the fixing projection. This will work
as a jack and release the rail out of the groove.
scREWs
gRoovEs
Rail With a
Fixing PRojEction
scREWs
7/8”WEavER
mounting systEm